The best flat roof roofing material is without a doubt a single sheet of rubber custom made for weather-proofing flat roofs, such as Firestone’s EPDM product.

That is laid directly onto roof boarding, itself supported by the roof rafters and nagging. Insulating material is normally laid in the space between your two, and if you’re renewing your flat roof anyway you may as well take the opportunity of renewing that as well.

This will almost certainly function as recommendation you receive from any reputable builder or roofer advising you on replacing your existing flat roof.

Until recently the most used material for a fresh flat roof was bituminous felt laid in three layers, the initial layer nailed down and top of the two bonded to the main one beneath with mastic bitumen. Based on the material used, this could mean heating a good bitumen-based compound to make it liquid, and then pouring it onto the underlying felt and spreading it evenly over the whole section of the roof.

Then you had to wait for the compound to cool before applying another layer, and by the end spreading a layer of stone chippings on the roof and bonding it with a chipping compound, this being to reflect the sun’s rays preventing the felt and bitumen degrading quickly.

This was altogether a fairly messy, complicated and time-consuming job best left to the experts. In addition, there were several stages where it was very easy to fail to make the roof weather-proof, e.g. where the edge of the felt met the prevailing tile or slate roofing of the pitch roof.

On top of that, if, or rather when, there developed a leak in the flat roof, it might be very difficult and messy to discover wherever the rain was getting back in. Seldom would the manifestation of the leak on the ceiling of the room below be directly below the foundation of it. Water could easily get by way of a weakness in the bitumen felt and travel along a rafter before descending to the ceiling board below.

The new generation of rubber-based flat roofing systems are far superior. If you have reasonable DIY abilities then you can certainly probably do-it-yourself, with one other person to assist. You can easily find a local supplier of rubber flat roof roofing material online, and the existing price is around �6.65 per square metre.

Most suppliers slice the material to the exact size and shape that you require so are there no unnecessary joins, meaning no weaknesses and an exceptionally long-lasting, leak-proof roof.

The vital area of the whole process is to ensure that there are no gaps between the rubber roof and any existing pitch roof where rain could possibly penetrate. To ensure there are no problems it is vital to run the rubber material up and under the tiles or slates of the adjoining pitch roof so that any rain dripping from the lower-most row falls onto the rubber, without possibility of it over-lapping the edge and getting within the pitch roof.

Also, make sure that the prevailing slope of the flat roof towards the guttering or other method of water escape is maintained. Roof moss removal near me is merely glued onto the roof boards and sealed where appropriate with metal brackets or bitumen in such a way that rain penetration is impossible. Mind that the glue covers the entire underneath of the rubber so as to avoid bumps in the surface which could obstruct the drainage of the water away.

Rubber roofs have been shown to last for well over 50 years under all weathers, so that it really is the only flat roof roofing material you need to consider when deciding on a new flat roof.

Leave a Reply

Your email address will not be published. Required fields are marked *